Post Date: August 16, 2019

The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

Conclusions and recommendations

If there are no recommendations to be manufactured as a result of the project, just call this section Conclusions.

The Conclusions section sums up the important thing points of your discussion, the essential features of your design, or the significant outcomes of the investigation. As its function would be to round off the story of assembling your shed, it will:

  • be written to relate directly to the aims associated with project as previously mentioned within the Introduction
  • indicate the extent to that the aims have now been achieved
  • summarise the key findings, outcomes or information in your report
  • acknowledge limitations and make recommendations for future work (where applicable)
  • highlight the value or usefulness of one’s work.

The conclusions should relate with the aims associated with the work:

The goal of this project is to design a cellular phone tower for a suburban location..

The cell phone tower presented here may be erected safely in a street that is suburban.

It entails an overall total part of a maximum of 2m 2 l, and has the following safety features.

This investigation will review the quantity of passengers making use of the Monash University Clayton-Caulfield inter-campus bus in order to recommend adjustments towards the service if required.

Analysis of the survey data obtained in this project reveals that usage of the Clayton-Caulfield inter-campus bus has grown by 24% in the past 5 years. It is strongly suggested that frequency be increased during peak usage.

The Conclusions section below is from a level 2 Civil Engineering Alternative Designs report presenting two designs for a an overpass bridge. Click the buttons that are coloured start to see the comments.


Each of the two bridge designs Lecturer’s comment:
An elegant beginning for a Conclusions follows on neatly from the preceding discussion. In this case, it also indicates that the aims associated with project have already been met. presented in this report fulfil the criteria specified into the project brief. Both designs Lecturer’s comment:
The main findings or outcomes – in this case the key popular features of the designs – are then recapped. Incorporate piers that are round piled foundations, which are used because the soil conditions are unknown and perhaps unstable. Design 1, an easy i-girder that is composite, gets the advantageous asset of being made of steel and thus has longer spans and fewer piers.

Design 2, a super-T beam br >Design 2 Lecturer’s comment:
The importance of the end result – in this case the final recommendation – is obviously stated. is therefore recommended. It includes Lecturer’s comment:
To finish off, the achievement of the project is reinforced. An overpass that is affordable superior durability, and fully meets what’s needed regarding the design brief.

Always address limitations and suggest how they might be overcome in the future work. The below that is excerpt through the Conclusions of a report on a project investigating the consequence of pulsation on heat transfer in horizontal pipe flow.

Experimental results Lecturer’s comment:
Key conclusions drawn through the project. revealed that pulsed flow without flow reversal had no effect that is significant with steady flow. Preliminary experiments with reversed flow, however, clearly indicated increased heat transfer. This really is likely due Lecturer’s comment:
Provide a possible explanation for notable results, especially unexpected ones. to the large disturbances within the boundary that is hydrodynamic as soon as the flow changes direction. Further research Lecturer’s comment:
Recommend further research to handle any work that is extra think will be useful. is advised to determine the most enhancement that is achievable.

It ought to be noted that Lecturer’s comment:
Acknowledge limitations or errors and suggest explanations solutions that are and/or. the experimental results try not to concur with the theoretical equations. This may be because of the deposits which developed in the pipe, or even to thermocouple temperature that is navigate to the web-site inconsistent. Therefore, regular inspection associated with test rig is recommended.

For a rather report that is long it really is acceptable to present the conclusions and recommendations in point form:

The prototype robot courier presented here has been confirmed to manage to delivering documents autonomously in an office environment. It has demonstrated the next aspects of mobile robotics:

  1. Localisation: The Kalman filter-based localisation algorithm achieved sub-centimeter accuracy under normal operating conditions.
  2. Environment modelling: The occupancy map was updated dynamically to incorporate obstacles not included in the original map.
  3. Path planning: A distance path that is transform-based using obstacle transforms produced a globally optimal local entrapment-free road to the goal.

Leave Comment

0 Comments on The Conclusions and Recommendations could be combined or, in long reports, presented in separate sections.

Leave a Reply

Your email address will not be published. Required fields are marked *